Portland Lantern Works Rame Copper Wall Lantern Medium

Hand seamed copper with a glazed front, made the way a marine lantern is made. Copper goes brown quickly and green slowly, and on a coast it does both faster. Sold singly.

Made in Cornwall from sheet copper of a gauge that is heavier than it needs to be. Every seam is silver soldered, not glued and not riveted, and the glass is bedded on a silicone gasket that can be replaced without breaking anything. Marine grade stainless fixings are supplied because plated steel screws will streak the wall inside a winter.

Specification

• Height 500mm, width 275mm, projection from the wall 210mm
• Materials: solid copper with 4mm clear glass
• Finish: unlacquered as standard so it patinates, lacquered to order
• Lamp: 1 x E27, maximum 60W, dimmable LED suitable
• Supply: hardwired, 220 to 240V, cable gland fitted in the base
• Switching: no integral switch, wired to a wall switch, a photocell or a PIR
• Rating: IP54, weather rated for sheltered exterior walls
• Backplate: copper, gasketed, with marine grade stainless fixings
• Weight: approximately 5.1 kilograms
• Fixings: A4 marine grade stainless, supplied
• Glass: replaceable without special tools
• Photocell and PIR versions available to order
• Sold singly

Fitting

This is a hardwired exterior fitting and should be installed by a qualified electrician working to BS 7671. The gasket and cable gland are supplied. Bed the backplate onto a bead of neutral cure silicone and leave the lower edge open so any moisture can drain. At roughly 5.1 kilograms it needs a proper fixing. Use the supplied screws into masonry, or a heavy duty plasterboard anchor rated well above the weight of the light.