Marlow and Reade Eynsham Recessed Bedside Reading Light Pair

Sits flush in the wall with only the head proud, for a headboard wall that has to stay clean. Needs a 90mm deep void, so check before you order.

Reading in bed is the one job a wall light does that a ceiling light cannot do at all, and most wall lights are not very good at it either. The rule we work to is that the light reaches the page and stops. That means a deep shade or a proper optic, a warm colour temperature, and a switch you can find without opening your eyes. Sold as a pair for either side of the bed.

Specification

• Height, per fitting: 180mm, width 90mm, projection from the wall 45mm proud of the wall
• Materials: solid brass and steel
• Finish: four finishes, applied to the metal itself
• Lamp, per fitting: integral warm white LED, 4W, CRI 92
• Supply: hardwired, 220 to 240V, or plug in with the optional cord set
• Switching: rocker switch on the backplate
• Rating: IP20, for dry indoor rooms
• Backplate: round, 95mm diameter, covers a single pattress
• Fixed arm and head
• Weight: approximately 2.8 kilograms for the pair
• Colour temperature: 2700K warm white
• Dimmable on a trailing edge dimmer
• Sold as a pair

Fitting

This is a hardwired fitting and should be installed by a qualified electrician working to BS 7671. It arrives with a standard round backplate and fixing screws. Wall plugs are not supplied because the right fixing depends on whether you are going into brick, block, plasterboard or lath and plaster. At roughly 2.8 kilograms it is light enough for a good quality plasterboard anchor if there is no timber behind. Fit it at about 1200mm off the floor, or 150mm above the top of the headboard, whichever is higher.