Corsham Bathroom Lighting Saltford IP44 Wall Light with a Pull Cord

A pull cord on the fitting itself, so a small bathroom does not need a separate switch outside the door.

Bathroom lighting is the one part of a house where the regulations are specific and worth reading. Zone 0 is inside the bath itself. Zone 1 is directly above it to 2.25 metres. Zone 2 extends 600mm out from zone 1 and around a basin. Outside those zones the ordinary rules apply. Everything in this group carries a real IP rating tested on the finished fitting, not on a sample of the housing, and every one is supplied with the gasket fitted.

Specification

• Height 220mm, width 140mm, projection from the wall 160mm
• Materials: brass or steel with sealed glass and a silicone gasket
• Finish: four finishes, all suitable for a humid room
• Lamp: integral warm white LED, 2700K, CRI 90, dimmable
• Supply: hardwired, 220 to 240V, 50Hz, terminal block behind the backplate
• Switching: brass pull cord on the underside of the backplate
• Rating: IP44, suitable for bathroom zones 2 and 3
• Backplate: sealed, gasket fitted, marine grade stainless screws
• Rating: IP44
• Suitable for zones 2 and 3
• Weight: approximately 1.6 kilograms
• Supplementary bonding is your electrician's responsibility
• Sold singly

Fitting

This is a hardwired bathroom fitting and must be installed by a qualified electrician working to BS 7671 Part 7 Section 701. Check the zone before you buy: zone 2 begins 600mm from the edge of a bath or shower and extends 2.25m up from the floor. At roughly 1.6 kilograms it is light enough for a good quality plasterboard anchor if there is no timber behind.