Chalkhill Studio Norbury Plaster Shell Uplighter Wall Light

A shell uplighter cast in fine plaster from a mould taken off a hand carved original. Left raw it takes emulsion straight from the tin, so it can disappear into the wall colour completely.

Cast in fine casting plaster reinforced with jute scrim, then rubbed back by hand. It arrives raw and slightly chalky. Most people paint it the colour of the wall so the fitting reads as part of the plasterwork, and it takes emulsion, chalk paint or limewash without a primer. Sold singly.

Specification

• Height 300mm, width 340mm, projection from the wall 150mm
• Materials: fine casting plaster on a jute scrim with a steel backplate
• Finish: raw plaster, ready to paint, or painted in one of three studio colours
• Lamp: 1 x E27, maximum 60W, dimmable LED suitable
• Supply: hardwired, 220 to 240V, 50Hz, terminal block behind the backplate
• Switching: no integral switch, wired to a wall switch or a dimmer circuit
• Rating: IP20, for dry indoor rooms
• Backplate: steel, 110mm diameter, painted to match
• Weight: approximately 4.8 kilograms
• Lead time: 3 to 4 weeks
• Hairline variation in the surface is characteristic of the material
• Sold singly

Fitting

This is a hardwired fitting and should be installed by a qualified electrician working to BS 7671. It arrives with a standard round backplate and fixing screws. Wall plugs are not supplied because the right fixing depends on whether you are going into brick, block, plasterboard or lath and plaster. At roughly 4.8 kilograms it needs a proper fixing. Use the supplied screws into masonry, or a heavy duty plasterboard anchor rated well above the weight of the light.