Marlow and Reade Turnham Traditional Brass Picture Light 600mm

The traditional half round hood on a swan neck, the fitting a gallery would have used before anyone thought of putting LEDs in a strip. The hood tilts through forty degrees so you can take the reflection off glazed work. Sold singly.

Made from solid brass in Birmingham with the LED board and driver built in, so there is no transformer to hide in the ceiling void. The board is specified at CRI 95 or better, which matters more on a painting than brightness does: a low CRI source flattens reds and greys and makes an oil look muddy. Every length is on the same 2700K bin so a wall of them matches.

Specification

• Height 110mm, width 600mm, projection from the wall 170mm
• Materials: brass hood with a tilting swan neck
• Finish: solid brass in your chosen finish
• Lamp: warm white LED strip, 2700K, CRI 95, 8 to 26W by length
• Supply: hardwired, or plug in with the optional cord set, 220 to 240V
• Switching: no integral switch, wired to a wall switch or a trailing edge dimmer
• Rating: IP20, for dry indoor rooms
• Backplate: concealed, fixes to the wall or to the frame
• Suitable for pictures 700mm to 950mm wide
• Colour temperature: 2700K warm white, fixed
• Dimming: trailing edge, down to 5 per cent
• Weight: approximately 2.8 kilograms
• Rated life: 50,000 hours
• Sold singly

Fitting

This is a hardwired fitting and should be installed by a qualified electrician working to BS 7671. It arrives with a standard round backplate and fixing screws. Wall plugs are not supplied because the right fixing depends on whether you are going into brick, block, plasterboard or lath and plaster. At roughly 2.8 kilograms it is light enough for a good quality plasterboard anchor if there is no timber behind. It can be fixed to the wall above the picture or screwed to the top rail of the frame itself, and both sets of fixings are in the box.