Foundry Nine Larkhall Cast Bronze Torch Uplighter Wall Light

A bronze torch bracket, the kind that lit a stair before there was wiring to light it. The flame is a hand blown glass cone that sits inside the cup and glows amber from the shoulder up.

Cast by the lost wax method in a Somerset foundry. A wax original is invested in a ceramic shell, the wax is burned out and the bronze is poured into the void that is left, which is why the surface holds so much detail. Every casting is then chased, patinated and waxed by hand. Sold singly.

Specification

• Height 420mm, width 150mm, projection from the wall 180mm
• Materials: solid bronze, sand cast backplate, cast bronze arm, hand blown glass cone
• Finish: hand applied patina over bronze, sealed with microcrystalline wax
• Lamp: 1 x E14 candle, maximum 40W, dimmable LED suitable
• Supply: hardwired, 220 to 240V, 50Hz, terminal block behind the backplate
• Switching: no integral switch, wired to a wall switch or a dimmer circuit
• Rating: IP20, for dry indoor rooms
• Backplate: cast bronze, 110mm diameter, 12mm thick
• Weight: approximately 5.8 kilograms
• Lead time: 4 to 6 weeks, cast to order
• Each casting is unique and small variations are expected
• Sold singly

Fitting

This is a hardwired fitting and should be installed by a qualified electrician working to BS 7671. It arrives with a standard round backplate and fixing screws. Wall plugs are not supplied because the right fixing depends on whether you are going into brick, block, plasterboard or lath and plaster. At roughly 5.8 kilograms it needs a proper fixing. Use the supplied screws into masonry, or a heavy duty plasterboard anchor rated well above the weight of the light.