Atelier Sconce House Denbury Cast Brass Sunburst Wall Light

Twenty four brass rays radiating from a central boss, each one filed and set by hand so the group is never quite symmetrical. Big enough to hold the end wall of a room on its own.

Made in our own workshop in England, one at a time, by the people who drew it. Pieces at this scale are built around a welded steel armature so nothing relies on the decorative metal for strength, and every one is wired with silicone insulated cable and a ceramic lampholder because the heat inside a large fitting is not the same as the heat inside a small one. Sold singly.

Specification

• Height 820mm, width 820mm, projection from the wall 150mm
• Materials: solid brass, bronze, iron and glass depending on the piece, on a welded steel armature
• Finish: hand applied and sealed, specify a bespoke finish if you need to match existing metalwork
• Lamp: 2 x E27, maximum 60W each, dimmable LED suitable
• Supply: hardwired, 220 to 240V, 50Hz, terminal block behind the backplate
• Switching: no integral switch, wired to a wall switch or a dimmer circuit
• Rating: IP20, for dry indoor rooms
• Backplate: concealed mounting plate with four M8 fixings
• Weight: approximately 19.4 kilograms
• Lead time: 8 to 12 weeks
• Contract and hospitality specification available on request
• Full photometric data supplied on request
• Sold singly

Fitting

This is a hardwired fitting and should be installed by a qualified electrician working to BS 7671. It arrives with a standard round backplate and fixing screws. Wall plugs are not supplied because the right fixing depends on whether you are going into brick, block, plasterboard or lath and plaster. It is a heavy fitting at roughly 19.4 kilograms, so fix into masonry or into a timber noggin behind plasterboard rather than into the board alone. At this weight the fixing must go into structure. We will send the mounting drawing to your electrician before delivery if you ask.